3.2 - PROCEDURE FOR SETTING THE LED TYPE
PROCEDURE
STEP 1
Press and hold buttons 1 and 2 simultaneously
(approximately 2 seconds) until the LED becomes
green.
STEP 2
Make a short press of button 1 on the receiver and count the
number of LED Flashes.
NUMBER OF
FLASHES
NUMBER OF LINES MANAGED
SEPARATELY
DESCRIPTION
1
1
4 single-colour LED strip lights in synchronised
mode.
2
2
2 lines of single-colour LED
3
3
3 lines of single-colour LED
4
4
4 lines of single-colour LED
STEP 3
Press the button P1 during the during the Flash that
corresponds to the function desired to end the count.
The yellow LED on the board blinks a number of times
corresponding to the set function
WARNING: if no setting is confirmed during step 3, the control unit mantains the load type previously set.
ACTION:
Long press of buttons 1 and 2
LED:
green
ACTION:
Short press button 1
LED:
yellow blinking
ACTION:
Short press button 1
LED:
Count the nuber of Flashes
9
