7.2 FUNCTION CUSTOMIZATION OF THE “WIRELESS BUS” GENERIC TRANSMITTER BUTTONS
The following procedure allows you to set a custom function to the “wireless bus” family transmitter button.
PROCEDURE
GENERIC RADIOTRANSMITTERS (WIRELESS BUS), CODES:
HB80-6G, MCU-TX4, TOUCH-1G, TOUCH-2G, TOUCH-4G, TOUCH-LOCK4, TOUCH-TX2, ROUND-1G
STEP 1
Short presses on the “SET” key let you scroll through the
menu until “P5” programming appears on the display.
STEP 5
Make a transmission with the transmitter to be saved
(see transmitter manual, paragraph entitled “transmitter
programming”).
The LED on the receiver Flashes 3.times and turns off.
STEP 2
Short presses on key “A” let you choose the output on which to
set the type of load, see following table:
DISPLAY
FUNCTION
1
Out 1
2
Out 2
3
Out 3
4
Out 4
STEP 3
Short presses on key “B” let you choose the type of output that you want
to set, shown on display “b”, based on following table:
DISPLAY
FUNCTION
1*
Multifunction transmitter
2*
Generic transmitter: On/Off
6
Generic transmitter: On
7
Generic transmitter: Off
* programming 1 and 2 are equivalent to the procedure of paragraph 4.1
ACTION:
Short presses of button SET
DISPLAY:
P5
ACTION:
Short presses of button A
DISPLAY:
1, 2, 3, 4, 1, 2...
ACTION:
Short presses of button A
DISPLAY:
1, 2, 6, 7, 1, 2...
ACTION:
Make a transmission with the transmitter
LED:
Flashes 3 times
STEP 4
Prolonged press on key “B” (approx. 3 seconds) activates the
receiver, the LED on the display TURNS on.
ACTION:
Long press of button SET
DISPLAY:
Led turns on
STEP 4
If you want to save other transmitters, go back to point 2 of this procedure. If you want to go back to the menu
displaying the different types of programming, give a prolonged press to the “SET” key (approx. 3 seconds).
17
