! Make sure to glue securely, If not
properly glued, a failure in flight may
occur.
Draw the center line on the wing joiner
- Trial fit each part before gluing . Be certain that there are no gaps.
If the parts will join, but with a gaps, sand or trim the parts a little
at a time until the parts meet exactly with no gaps.
- Check for the correct dihedral angle
Hold the wing halves together with paper clamp
and rubber band
.
Before gluing:
- Draw the center line on the wing joiner.
Note: The two wing halves roots must fit together perfectly.
IMPORTANT:
Please do not clean off the excess epoxy on the wing with strong
solvent or pure alcohol, only use kerosene to keep the colour of your model not fade.
A B
A B
A B
Glue must go inside
Wing joiner
Glue
Wing half
A B
A B
Rubber band
(not include)
Paper clamp
(not include)
Nylon wing bolt
(included)
82mm
Joining the wing halves
INSTRUCTION MANUAL / SPITFIRE
TOP-VIEW
30 min.Epoxy
30 min.Epoxy
30 min.Epoxy
13
