Nexa BALENO 2016, Owner'S Manual & Service Booklet, Page: 97 / 334

2-71
BEFORE DRIVING
68PH0-74E
Security system “ ”
• : Enable the security system
(default setting)
• : Disable the security system
Shock sensor “ ”
• : Enable the shock sensor
• : Disable the shock sensor
(default setting)
Pre-warning sensitivity of
the shock sensor “ ”
• : Disable the pre-warning
• to :
Adjust the pre-warning sensi-
tivity of shock sensor (Lowest
sensitivity level is L01 and
highest is L15, and default
setting is L14)
Full blast warning sensitivity
of the shock sensor “ ”
• : Disable the full blast warning
• to :
Adjust the full blast warning
sensitivity of shock sensor
(Lowest sensitivity level is L01
and highest is L15, and
default setting is L09)
Initialization setting “ ”
• : Initialize all settings
68PM00272
NOTE:
• As shown in the above illustration, “SEL”
indicates on the display of currently set-
ting item.
• To go back to the higher level display
during operation, turn the indicator
selector knob (3) to display “ ” or
“ ” and then push the indicator
selector knob (3).
• If the security system “ ” is in the dis-
abled state, the shock sensor “ ”, pre-
warning sensitivity “ ” and full blast
warning sensitivity “ ” cannot be set
up.
5) to exit the setting mode, switch the dis-
play to show “ ” and then push the
indicator selector knob (3).
EXAMPLE