Copyright Velocomp LLP 2005-2015
12
5.
Start riding
. After 8 seconds the Newton screen changes. “Cal” appears in the
middle window, and “Start” flashes in the bottom window.
6.
If you want to keep riding and start your Cal Ride at a different place from your
current location, that’s OK! Just keep riding to your desired starting point; whil
you ride to it the “Cal Start” message will continue to flash.
7.
When you are ready to begin the Cal Ride,
click the center button
to start the
Cal Ride.
8.
The top window shows bike speed, the center window alternates between “Cal”
and distance traveled, and the progress bar fills as you ride.
9.
During the Cal Ride you can bike at a leisurely pace, and it’s OK to stop if
needed. Your Cal Ride will be unaffected.
10.
Ride for five minutes, until
“go bac(k), turn 180 degrees”
flashes
.
11.
If you still need to keep going a ways before turning safely, it’s OK.
12.
When safe,
slow to a STOP
,
then turn around
.
13.
Ride back to the starting point,
along the same route
as the “Out” portion of
your ride.
14.
The progress bar empties as you ride back.
Keep riding until the progress
bar is completely empty,
and
“Cal Done” flashes.
15.
Once the Cal Ride is completed, your Newton returns to its normal
screens, and your Newton is ready to ride.
NOTICE
: AFTER BEGINNING YOUR CAL RIDE, IF YOU WISH TO TERMINATE (ABORT) IT,
PRESS-HOLD THE CENTER BUTTON FOR TWO SECONDS. THIS ABORTS THE CAL RIDE
AND LEAVES ANY PRIOR RESULTS UNCHANGED.
