NewTek NDI HX-PTZ2, Operating Instructions Manual

Page: 16 / 46

Page | 12
2.3
LENS HOOD INSTALLATION
There are rare occasions when a light source near the camera enters at such an angle it causes lens glare. If
this happens, we have provided an accessory hood that can be installed to remove the glare.
Included in the installation kit: Hood sheet with double-sided tape edge Fixing tape.
2.3.1
INSTALL IN 5 SIMPLE STEPS
Step 1
Take the hood sheet and remove the
double-sided tape from one end using the tab.
Step 2
Bend the hood, bringing together the ends and
inserting the smaller end into the slot to the left
of the adhesive area. Once inserted, press firmly
to ensure the adhesive sticks.
Step 3
To attach the hood, align the notch in the hood
to where the upper and lower lens cover meet.
Push the hood onto the camera as shown.
FIGURE 20
FIGURE 21
FIGURE 22
FIGURE 18
FIGURE 19