© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
198
SLIDEOUTS
Option 2
1. Remove the four mounting bolts, and move each
slideout motor until it disengages from the square
shaft.
2. Manually push the room in or out, or use a wrench to
rotate the shafts. Make sure you do not damage the
shafts with the wrench and keep the room in sync to
prevent binding.
WITH MANUAL LOCK ARMS
3. Lock the room with manual lock arms (if equipped).
4. Take the coach to an authorized service center for
diagnosis and repair.
WITH MECHANICAL LOCK ARMS
3. Slide the motor back over onto the square shaft, and
reinstall the four mounting bolts.
4. The motor and brake assembly must be installed
(or another way devised) to hold the slideout in the
retracted position prior to traveling.
5. Take the coach to an authorized service center for
diagnosis and repair.
Depending on the year, model, and floorplan of the
coach, the exact slideout motor(s) location may vary.
Generally, they may be accessed from under the
slideout in the compartment area. Some motors may
also be located in the wheel well area under a cover.
NOTICE
!
Hydraulic Slideouts
The operating switch for the Hydraulic Flat Floor Slideout
is usually located in the overhead control panel.
Due to the slideout safety feature commonly referred to
as ‘ignition lockout’, the operation of your slideout will be
prohibited under one or more of the following conditions:
•
Total slideout operation is prohibited when the
ignition switch is in either the accessory or run
position.
•
Total slideout operation is prohibited when the park
brake is not set.
Read entire slideout room instructions posted in your
coach before extending or retracting the slideout.
IMPORTANT
!
WARNING
!
Read the HWH Operation manual for your slideout
and follow all safety warnings and notices.
CAUTION
!
When operating the HWH Hydraulic Flat Floor
Slideout, the coach must be plugged into shore
power or operating on generator power with full
voltage, or damage could occur to the coach.
During normal operation of the room, do not reverse
direction of the room until the room is fully extended.
If necessary, the direction of the room may be
reversed, but watch for binding of the room. If the
direction of the room has been reversed, do not
re-extend the room until the room has been fully
retracted, as the room may not drop to the level out
position.
NOTICE
!
This article provides basic operation instructions for a HWH hydraulic slideout.
HWH Hydraulic Slideout Operation
The disabling of the slideout is based on the individual
slideout control module programming and the ignition
switch circuit signal.
Once the appropriate safety feature conditions are met
and the path of the slideout is unobstructed both inside
and outside of the coach, follow the operating instructions
posted in your coach.
Do not hold the ‘in’ or ‘out’ switch for more than ten
seconds after the room has stopped moving from
the fully retracted or fully extended position. If at any
time the slideout stops or is in a bind, release the
slideout switch immediately. Do not force the room
or reverse directions. Contact Newmar Customer
Service for assistance.
IMPORTANT
!
Summary of Contents for Mountain Aire 2022
Page 1: ...SM 2022...
