© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
131
ENTERTAINMENT SYSTEMS
AUTO POWER OFF
If there is no signal input in any mode, the TV
will automatically access the standby state after
approximately 15 minutes.
MEMORY BEFORE TURNING TV OFF
The settings of picture and the preset channels will be
memorized at turning off the unit. When it is started up
again, the unit will work according to the mode set before
being turned off.
DVD Operation
1. Press the Eject ( ▲ ) button on the
side panel or on the remote.
2. After placing a disc in the disc tray,
press the ⊲
||
button to play the
disk, and press the ⊲
||
button twice
to pause the disk.
Basic Operation
TURNING THE TV ON OR OFF
1. After attaching cable to either an antenna or a cable
service, insert the power cord plug into a polarize AC
outlet.
2. Press the POWER button on the LED TV.
3. The normal picture will be displayed on the screen
after six seconds. If no signal, “No Signal” will display
on the screen.
4. If temporary POWER of is required, press the POWER
button on the LED TV.
5. If you want to completely switch off the power for this
unit, unplug the power cord plug.
6. After switching off the unit, you should turn on the TV
again at least five seconds later.
STATUS INDICATION LAMP
1. Green: In power on mode.
2. Red: In standby mode.
Source(s): Skyworth LED HD TV/DVD Combo User’s Manual
Product(s): Skyworth 19” LED HDT TV/DVD Combo (Model: SLC-1921A-
3S, Newmar Part Number: 145572)
Television Lift Operation via KIB Touchscreen
This article provides basic operation instructions for a television lift (televator) via a KIB touchscreen.
Operation
On some coaches, the TV lift controls are integrated into
the KIB touchscreen switches (if equipped) and is labeled
TV LIFT UP or TV LIFT DOWN. The touchscreen buttons will
turn red while active and grey while not active.
1.
From the Home Menu, press the Systems button.
2.
Press and release the TV Lift Up button to raise the TV.
3.
Press and release the TV Lift Down button to lower the
TV.
4.
The lift will continue in the selected direction until it
reaches the end of travel. If you need to stop it at any
time during the travel process, press the switch again
in either direction.
Television Lifts
Televator control switches and touchscreen buttons
should be pressed and immediately released. Do not
continue to hold the UP or DOWN switch or button,
as this may cause the television lift to enter into
programming mode.
NOTICE
!
Note: If programming mode is reached, refer to the re-
calibration article in Newgle for more information.
Televator During Travel
Lower the television lift completely for travel to
prevent damage to the television and surrounding
equipment.
IMPORTANT
!
Summary of Contents for Mountain Aire 2022
Page 1: ...SM 2022...
