© 20201Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
42
CHASSIS
TO USE ACC MODE WITHOUT
STARTING THE COACH
Without pressing the brake pedal
(with the key fob within range):
•
Press the START button one
time to put the coach into
“Accessory” mode.
•
Press the START button two
times to turn on the ignition
and dash lights.
ALTERNATE STARTING PROCESS
When the primary starting sequence is not operating as
expected, the alternate method is required when any of
the following conditions are true:
•
Smart Key Fob battery is dead
•
Smart Key Fob is not working correctly
•
Primary Brake air tank is empty
Use the lock button end of the Smart Key Fob to contact
the engine START/STOP button directly. A single press of
the engine START/STOP button with the Smart Key Fob
will change as follows:
•
OFF > ACC > ON > OFF
System Operation
HOW TO REPLACE THE SMART KEY
FOB BATTERY:
1.
Use a small coin or screw driver (-) to open the smart
key fob.
2.
Use one new standard CR2032 battery to replace
with the old battery. Then, close the smart key fob.
3.
The smart key fob reassembly (closing) process
should be completed in the opposite order of the
smart key fob disassembly (opening) process.
4.
Once the battery is successfully replaced, please
check if the smart key fob functions properly.
WHEN TO REPLACE THE SMART KEY
FOB BATTERY:
1.
When the ignition is active and the smart key fob
battery is between 1 to 2.15 V, the instrument cluster
will display ‘Check Battery’. This alerts the driver that
the smart key fob battery needs to be replaced.
2.
When the smart key fob does not function properly,
battery drainage could be the reason and battery
replacement should be considered although the
smart key fob battery is designed to last for a few
years.
Smart Key Fob Battery
Replacement
TO TURN ENGINE OFF
To shut the engine off while the coach is in neutral, press
and release the START button. With the coach in drive,
press and hold the START button for three seconds.
TO START THE ENGINE
To start the engine, depress
the brake pedal and press the
START/STOP ENGINE button with
the transmission shifter in neutral
(N). If the wait to start lamp is
active, a second button press is
required to start the engine.
If the engine is cold, the “wait to start” light will
display on the dash. The engine will not start until the
light disappears.
IMPORTANT
!
Press and hold the engine START/STOP button for more
than one second with the Smart Key Fob to start the
engine. The engine can start without depressing the
brake pedal, but for your safety, always depress the brake
pedal before starting the engine.
Source(s): Namsung Smart Key Fob Battery Replacement
Source(s): Freightliner Recreational Vehicle Chassis Operator’s Manual 2018
(Driver Controls)
Summary of Contents for LONDONAIRE 2022
Page 1: ...SM 2022...
