© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
105
ELECTRONICS
Source: RV Toll Pass
Can I Tow My Vehicle or
Trailer?
Toll authorities that charge by number of axles typically
utilize automatic axle counters to charge a toll based on
the actual number of axles. Some toll authorities rely on a
code programmed within the transponder to convey the
toll rate category based on axles, tires and weight. Your
RV Toll Pass transponder contains a code matching the
toll rate category of your RV. If you are traveling with a
towed vehicle or trailer, check with the Toll Authority and
follow their guidance.
Trimark Electronic Access Security Keyless-Entry
Operation (e-FOB / e-PAD)
This article provides basic operation instructions for a Trimark Electronic Access Security Keyless Entry (e-FOB / e-PAD) system.
E-Pad Operation and Features
LOCK DOORS WITH KEYPAD
•
Press and hold down the (1) button for 1-2
seconds. An access code is not needed
to lock the doors.
DOOR BELL OPERATION
•
The doorbell button provides a 0.5
second ground pulse from the 2nd
Auxiliary output when pressed. An access
code is not necessary for the doorbell.
USING SECURE OPERATIONS
•
Entering a valid 5-digit access code
provides a double beep and enables
a secure operation. After entering an
access code, the keypad is enabled for 5
seconds.
•
The next button pressed initiates a secure
operation, such as unlocking doors.
Security and Keyless Entry Systems
AVAILABLE SECURE OPERATIONS
Button (1): Unlock entry doors.
Button (2): Unlock doors wired to 2nd unlock output.
Button (3): NA
Button (4): Sequentially activate entry unlock and 2nd
unlock outputs.
LIGHT ACTIVATION
When the alarm is armed, the parking lights and
headlights flash. With an unlock instruction from either the
fob transmitter or keypad; the dome light stays illuminated
for 30 seconds and the parking and headlights flash.
Teaching Keypad New
Authority/Access Codes
The Authority Code has only one purpose; it grants the
owner the ability to set new Access Codes. The Authority
Code must be EXACTLY 5 digits long. There are two ways
to set the Authority Code with the TriMark Full Feature
System. Changing the Authority Code erases all previous
Access Codes and sets a new Access Code in memory
bank 1 that is the same as the new Authority Code.
1. Press and release the push button 3 times. Wait 3
seconds. The keypad will beep for 3 seconds. The
keypad is now in “Learn Mode”.
For Newmar’s location of the switch to reset and reprogram
the Trimark Keyless Entry System, refer to the “Trimark
Keyless Entry Reset/Program Switch” article in Newgle.
NOTE FROM NEWMAR
2. Enter a new 5-digit Authority Code. (Double chirps
after each button press). The keypad chirps 3 times
after the 5th digit’s entry.
3. Re-enter the new Authority Code for confirmation.
The keypad will chirp FOUR times after successful
confirmation. A long beep indicates a failure to change
the code.
4. Test the new code to confirm it.
•
The user is given 2 minutes to complete this
procedure. If it isn’t completed in time, or an error
is made, the system will exit learn mode and a long
chirp will sound to indicate the error.
•
While in “Learn Mode,” each button push provides a
double-chirp and the backlight flashes.
Summary of Contents for LONDONAIRE 2022
Page 1: ...SM 2022...
