© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
126
EXTERIOR
Girard Awning Operation via Wall Switch and Remote
(Model: G and Nova Series)
This article provides basic operation instructions for a Girard Awning via Wall Switch and Remote (Model: G and Nova Series).
How To Operate The Awnings
CAUTION
!
Never leave awning(s) extended without AC power
available to retract awning(s) via the motion/wind
sensor.
Girard awnings may be operated in light wind and
rain conditions. When periods of heavy rain and/or
high wind are expected, the awning must be closed.
Damage caused by wind and rain is not covered by
warranty.
IMPORTANT
!
CAUTION
!
Never leave the awning open and unattended. All
awnings must be closed prior to moving the vehicle
for any reason. As an extra safety precaution, check to
make sure every awning is fully closed. Before using
your awning, ensure that the surrounding area is
free of obstructions (trees, walls, pillars, posts, other
vehicles, etc.). Damage caused by failure to comply
with these instructions is not covered by warranty.
The awnings will not extend when the park brake
is released. However, the main awnings will retract
when the park brake is released if they are still
being supplied with 120 volt power. All other Girard
door and window awnings (if equipped) will lose
power and will not operate when the park brake is
released.
NOTICE
!
Before using your awning make sure that all of your
electrical circuits are operating correctly. Recreational
Vehicles can generate AC power from three separate
sources. The electrical system transfer switch in your
vehicle will select power for the awning as follows:
1. Shore Power – if connected;
2. Generator Power – if the generator is running;
3. Inverter Power – batteries must be charged for
inverter operation.
The main patio awnings are operated by a handheld
remote switch or a switch mounted in the overhead
cabinets or on the wall in the passenger cockpit area.
The exact location may vary by coach model and year.
Most switches are remote-battery operated. Girard
recommends replacing the batteries every year.
Source(s): Girard Multi-Channel Wall Switch (98GC782) Overview
Product(s): Girard Nova Series Awning (Model: NOVA, Newmar Part Number:
NovaAwning)
Source(s): G-2000 Patio Awning G-1500 Door Awning Installation, Operation,
Adjustment, and Repair (REV. 01272016)
Product(s): Girard G Series Awning (Model: G2000, Newmar Part Number: G2000)
C / - BUTTONS
To operate the awnings, change the channel until the
visual indicator displays next to the channel you wish to
select:
•
Channel “1” selects the front main awning
•
Channel “2” selects the rear main awning
•
Channel “0” OR “All” selects all active channels for
Girard awnings at the same time.
IN/OUT/STOP BUTTONS
Use the “In/Out” or “Stop” buttons to operate the awning
after the desired channel(s) are selected.
•
Press and release the “Out” button to extend the
awning(s).
•
Press and release the “In” button to retract the
awning(s).
•
Press the “Stop” button during extension or
retraction to stop the awning(s) in the desired
position between full extension and full retraction.
LOCK/UNLOCK BUTTONS
•
Pressing and holding the lock button for 10 seconds
will lock the switch panel or the handheld remote
control individually. While in lock mode, the display
will show the letter “L,” and the other buttons will be
inoperative. This will prevent accidental operation
while locked.
•
To unlock, press and hold the the unlock button for
10 seconds.
Note: If the awnings are in the extended position and
the remote is locked, the awning will still operate via the
motion/wind sensor as long as AC power is present to
operate the awning(s).
LIGHT BULB BUTTON
To turn on or off the awning lights, press the “Light Bulb”
button. The button alternates the lights between on and
off.
Summary of Contents for LONDONAIRE 2022
Page 1: ...SM 2022...
