42
Hetas registered (England & Wales) or equivalent for other Nations.
Open the door. Remove the glass panel by removing the 4 screws and fixing tabs located to the
inside of the door, the glass panel will require supporting during this process. Remove the glass
panel. Check the glass rope seal for wear and damage, if found replace the rope seal. When fitting
the new glass panel locate the glass so it is central to the stove glass seal and located correctly to
ensure the glass panel will be sealed to all sides. Replace the 4 screws and fixing clips and secure
the glass panel to door.
Do not
over tighten the screws as this can damage the glass.
Replacing the glass rope seal
Remove the stove door by removing the 4 screws retaining the hinges to the door and place face
down onto a soft sound surface so as not to damage the door or glass. To replace the glass panel
to door seal: Remove the glass panel. Note the position of the glass rope seal join positions in
relation to the door. Remove the old door rope seal and scrape old glue from the door locating
groove.
Clean the locating groove with a clean, dry cloth to remove all old dust and debris. Use suitable
stove rope glue into the rope locating groove and press the new rope into the locating groove,
noting the joint positions. Replace the glass panel. Refer to the stove rope glue manufacturer’s
instructions for drying times and when the stove can be used after the stove rope glue has been
used.
Using the appliance with a damaged glass seal or damaged glass can cause dangerous fumes to
enter the room, or the appliance to over fire resulting in damage.
Figure 6
