17
Interaction
Disable beep after scan: Enable or disable the emission of good read beep.
Enable launch CIT on boot: Choose whether to start built-in CIT app on boot or not.
Enable persistent immersive: If you disable the persistent immersive mode by selecting
“
No
”
, the
status bar and navigation bar will appear with an inward swipe from the top or right edge of the screen
when the CIT app is in the immersive mode.
Display brightness: Choose an appropriate screen brightness level as per the user environment.
Scanner sensitivity: There are three options for setting the IR sensitivity. Choose an appropriate
sensitivity level that fits the user environment.
GPIO
Server message prefix: Set the prefix that will be added before GPIO input data.
Append event counter: Choose to append the count of signal level changes or not as per your actual
needs.
Method: Choose one of the following three methods to read data from GPIO port:
On read GPIO
–
Read data using a read command
On change
–
Read data when signal level changes
Poll
–
Read data by polling the port
Poll speed(seconds): Set the polling interval.
Touch screen
Server message prefix: You can define a prefix so that the database identifies the touch
“
key
”
similar
to identifying a barcode.
Touch keyboard timeout(seconds): The time during which the keyboard/button is shown on the screen
before the NQuire returns to idle state.
Note:
When you finish making changes to the parameters in a box, do not forget to click
“
Apply settings
”
to
save the changes.
