Enter Setup
7 *
* Exit Setup
Power On, Sleep, Power Off, Reboot
Power on the scanner
Connect the scanner to a Host. Then the scanner will be turned on and automatically enter the sleep
mode.
Enter the sleep mode
If no operation is performed on the device for some time, the device will automatically enter the sleep
state.
Power off the scanner
Remove the communication cable from the scanner; or remove the communication cable from the Host;
or disconnect the power adaptor from mains.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, turn off the scanner and then turn it back on.
Maintenance
The scan window should be kept clean.
Do not scratch the scan window.
Use soft brush to remove the stain from the scan window.
Use the soft cloth to clean the window, such as eyeglass cleaning cloth.
Do not spray any liquid on the scan window.
Do not use any detergent to clean other parts of the device except for water.
Note: The warranty DOES NOT cover damages caused by inappropriate care and maintenance.
Summary of Contents for NLS-HR3290
