Enter Setup
** Exit Setup
128
Change Data Format for a Single Scan
You can switch between data formats for a single scan. The next barcode is scanned using the data
format selected here, then reverts to the format you have selected above. This setting is valid only when
the
Multiple Data Formats
feature is turned off.
For example, you may have set your scanner to use the data format you saved as Format_3. You can
switch to Format_1 for a single trigger pull by scanning the
Single Scan
– Format_1
barcode below.
The next barcode that is scanned uses Format_1, then reverts back to Format_3.
Note: This setting will be lost
by removing power from the scanner, or turning off/ rebooting the device.
Single Scan
– Format_0
Single Scan
– Format_1
Single Scan
– Format_2
Single Scan
– Format_3
Summary of Contents for NLS-HR3290
