Newland NLS-FM515 Series, User Manual

Page: 51 / 162

Enter Setup
41
** Exit Setup
Set Bad Read Message
A bad read message can contain up to 7 characters (HEX values from 0x00 to 0xFF). To set a bad read message, scan the
Set Bad Read Message barcode, the numeric barcodes representing the hexadecimal values of desired character(s) and
the Save barcode.
Set Bad Read Message
Set the bad read message to “F” (HEX: 0x46):
1. Scan the Enter Setup barcode.
2. Scan the Set Bad Read Message barcode.
3. Scan the numeric
barcodes “4” and “6” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from
the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.
Trigger Commands
When Enable Trigger Commands is selected, you can activate and deactivate the scanner in the Level mode with serial
trigger commands. Sending the Start Scanning command (default: <SOH> T <EOT> , user-programmable) to the scanner
in the Level mode activates a decode session. The decode session continues until a barcode is decoded or the decode
session timeout expires or the scanner receives the Stop Scanning command (default: <SOH> P <EOT> , user-
programmable).