Installation Instructions
Before operating your wine cooler for the first time, follow these steps:
z
Remove the exterior and interior packaging.
z
Check to make sure the following parts are included:
9
6 slide-out shelves
9
1 instruction manual
z
Before connecting the unit to a power source, allow it stand upright for approximately 2 hours.
This will reduce the possibility of any system malfunctions which may have occurred from
handling during transportation.
z
Clean the interior surface of the unit with lukewarm water and a soft cloth.
z
Place the wine cooler on a leveled surface that will be strong enough to support the unit when it is
fully loaded. To level your wine cooler, adjust the front feet located at the bottom of the unit.
z
Install the wine cooler away from direct sunlight and heat sources such as stoves, heaters, or
radiators, as direct sunlight may affect the unit’s acrylic coating, and nearby heat sources can
increase electrical consumption. Moreover, extreme cold or hot ambient temperatures may also
prevent proper performance.
z
PLEASE NOTE:
This wine cooler is only designed for home use, and is not designed to be
placed in a garage or basement.
Electrical Connection
To ensure safety and proper operation, please follow the guidelines listed below:
Warning:
Improper use of the grounded plug can result in electrical shock. If the power cord
appears to be damaged, have it replaced by an authorized service center.
•
This wine cooler should be properly grounded for your safety, and in order to minimize the
possibility of electrical shock, the power cord of this unit is equipped with a 3-pin plug which
fits with 3-pin wall outlets.
•
Never cut or remove the ground wire from the supplied power cord.
•
The use of extension cords is not recommended.
•
This unit requires a standard 110V-60HZ electrical outlet with a 3-pin plug. The cord should
be secured behind the wine cooler. Also, to prevent accidental injury, do not expose or dangle
the cord.
