New Leader Hi-Way XT3 TYPE II, Operator'S Manual

Page: 13 / 100

- 13 -
XT3 TYPE II
www.NewLeader.com
(800) 363-1771 316535-AA-A
Header
NAVIGATING ROUGH & UNEVEN TERRAIN
Figure 2.1 - Turn slowly and be careful when traveling on rough
surfaces and side slopes. Avoid holes, ditches and obstructions that
may cause machine to roll over, especially with a loaded spreader.
Never drive near the edge of a gully or steep embankment .
Load may shift, causing vehicle to tip.
Figure 2.1
Transportation & Handling
General Safety Rules
TRAVELING & TRANSPORTING ON PUBLIC ROADS
Always walk around and visually inspect the machine before traveling on public roads. Check for
damage and/or faulty components that can fail and create a hazard or unsafe condition. Make sure
all machine systems operate properly, including but not limited to: headlights, tail and brake lights,
hazard warning lights, turn indicators, parking brake, horn and rear view mirrors. Repair or replace any
component that is not in proper working order.
Never drive machine at a speed that causes it to bounce or cause loss of control.
Obey all traf fi c safety laws and regulations. Operate the machine with hazard warning lights on, unless
prohibited by law. It is the operator’s responsibility to activate and use road lights properly while
traveling on public roads.
Cover all loads that may spill or blow away. Environmental damage may result. Do not spread dusty
materials where dust may create pollution, visibility issues or interfere with traf fi c on public roads.
When transporting equipment or machine on a trailer, ensure it is properly secured. Be sure that SMV
signs on equipment or machine are covered while in transport on a trailer.
Be aware of overhead structures and power lines. Make sure machine can safely pass under. Refer to
“Dimensions & Capacities” pages in the Operations section of this manual.