New Image FG01, Assembly And User'S Manual

Page: 6 / 16

CHANGING THE QUAD PAD CONFIGURATION:
Your FITT Gym is designed to use the quad pads in a variety of ways, depending on
the requirement of the exerc
ise. Your FITT Gym arrives in quad configuration. To
change configurations use either A or B methods below:
Make sure all four pads are gliding smoothly after the configuration has been changed.
Use a combination of
A and B to create your
desired configuration.
A: To split the pads left and
right change New Image
locking key on all four pads
from horizontal to vertical
position.
B:
To split the pads top and
bottom, on both outer side
of track, under pads, release
hinge latch.
6. To attach pulley wheel, insert threaded
pin (Part #8) fixed to pulley wheel
through holes on main frame and secure
by screwing on pulley tightening knob
(Part #9). Pulley is labelled with left
or right sticker to ensure you attach
the correct pulley (sticker facing
outwards). Ensure the cable and handle
end is over the top of the pulley wheel
facing towards the bottom of the unit.
Insert short screw (part #5a) through
opposing end of cable ensuring cable
is underneath the pulley wheel. Thread
the short screw (Part #5a) into position
1 (see diagram). Ensure the screws are
tight before use. Once compete carry
out same instruction for other pulley.
Always ensure that the pulley tightening
knob is securely fixed before each use.
WARNING: Do not kneel when using
pulleys as may cause serious injury.
Attaching safety screw
6