Wood Post Layout & Installation
Using Round Post Bracket Kit
for Concrete or Wood Surface
Measure and locate the centre of the wood post. Pre-drill a
1/16”
[
2
mm] hole, about 1 1/2” (38mm] deep as shown.
Using the small screw provided with the ground bracket kit,
fasten the bracket to the bottom of the post as shown.
Position the ground bracket so that it is square to the wood
post
and pre-drill
three
,
3
/16” [
5
mm] holes for the lag bolts as shown.
The holes should be approximately 3” [75mm] deep.
Using a socket wrench, fasten the 3 lag bolts supplied with the
kit as shown.
1
OPTIONAL STEP
2
3
4
8
12 x 12 Round Post Louvered Pergola
Note: for additional information on the Round Post Bracket Kit
installation, refer to the Round Post Bracket Kit instructions.
www.newenglandarbors.com
www.newenglandarbors.co.uk
1
4
3
2
Make sure wood post
is square to bracket.
4”x4“x94” (10x10x239cm)
Note
: Easiest way to measure and mark
the center of the post is to draw
an ‘x’ through the diagonals as
shown.