Vinyl Column Assembly & Installation
Over Wood Posts
Slide the Main Column Top over the Post Adapter as shown.
NOTE: Do not glue the Column Top at this point.
Note the location of the hole(s) on the Column Top and compare
it to the overall layout of your pergola. The direction in which the
holes face will determine the placement of the beams, rafters, and
louvers.
With a pencil, make a centre mark through the hole onto the
wood post.
Remove the Column Top and drill a 1/2” (13mm) hole through the
wood post as shown.
Replace the Column top and visually check that the hole is
completely drilled through.
Apply a small amount of glue to the inside of the Column Top
as shown and place the Post Cap as shown.
To secure the Column to the wood post, fasten 4, 2 1/2” (64mm)
screws through the column into the wood post approximately
8” (20cm) from the ground as shown.
1
STEP THREE
2
5
4
3
6
www.newenglandarbors.com
www.newenglandarbors.co.uk
1
2
3
5
4
6
8”
(20cm)
12
12 x 12 Round Post Louvered Pergola