11
12 x 12 Round Post Louvered Pergola
Vinyl Column Assembly & Installation
Over Wood Posts
With a helper and a ladder, place the round post over the wood
post as shown.
Apply a small bead of glue around the base as shown,
approximately 4” (10cm) from the ground.
Slide the Round Post Base Trim over and down the post as
shown. Hold the base trim in place for about 20 seconds to
allow the vinyl glue to set.
NOTE: the Base Trim and ground bracket /wood post
should be square to each other.
Slide the Round Post Trim followed by the Round Post Top Trim
as shown. Let the two parts slide down for now as they will be
glued in place in later steps.
Attach the Round Post Adapter onto the top of the post and
fasten in place with 4, 5/8” (16mm) screws as shown.
Apply a small amount of glue to the inside of the Post Top Trim
where it would come in contact with the Post Adapter as shown.
Slide the Post Top Trim in place and hold for 20 seconds, allowing
the glue to set.
Apply a small amount of glue to the outside of the post where you
would like the Round Post Trim to be located (shown is 3” - 7.6cm)
Slide the Post Trim in place and hold for 20 seconds.
1
STEP THREE
2
3
6
5
4
7
9
8
1
2
4
3
5
9
6
7
8
www.newenglandarbors.com
www.newenglandarbors.co.uk