[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Resetting Parameters to Default Values
[ENG] [IOv2] Resetting Parameters to Default Values
–
•
•
•
•
[ENG] [IOv2] Resetting Parameters to Default Values
To reset parameters to default values, perform the next actions:
Power off a device;
Install a jumper;
Switch power on;
Remove a jumper 5-10 seconds after switching power on.
If a procedure is performed successfully, a LED light will blink initiating reset of parameters.
After resetting parameters to default settings there is a need to do an initial configuration of a device.
On default, the next parameters of a device are set:
User name:
visor
Password:
ping
IP address:
192.168.0.100
Subnetwork mask:
255.255.255.0
Gateway:
not set
SNMPcommunity:
SWITCH
MAC-address:
00 a2 xx xx xx xx
Here xx xx xx xx corresponds to a serial number of a device. Thus, all devices after being manufactured have
unique MAC-addresses.
