[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Connectors and Indicators
[ENG] [IOv2] Connectors and Indicators
–
1.
2.
[ENG] [IOv2] Connectors and Indicators
A front panel of a NetPing IO v2 device is represented on the picture below:
On a front panel of a device, there are 2 Ethernet 10/100-BASE-TX sockets. A device can be connected to the
Ethernet network using any of these connectors. The second connector may be used for plugging any network
devices, including other NetPing devices.
Operation modes of a power indicator
Event
Indication
Turning a device on.
LED blinks several times. A number of blinks depend on a length of a starting
procedure and may be different for different firmware versions. Blinking does not
continue more than 2 seconds and is continued until a device is internally
initialized. If blinking continues for more than 2 seconds, this means that
parameters of a device are reset to default values at the start (see below in this
table).
A device is turned on,
there is no activity.
LED lights continuously.
A device transmitted a
package
LED blinks once for very transmitted package.
Firmware of a device is
updated.
Firmware of a device is updated in two stages:
During the first stage, firmware is uploaded to a device. LED blinks in a standard
indication mode for receiving packages.
During the second stage, firmware is updated in a device. LED blinks rapidly
during this process.
After firmware updating, a device is rebooted. LED operates in the mode that
corresponds to turning a device on.
