WG103 ProSafe 802.11g Wireless Access Point Reference Manual
A-2
Technical Specifications
v1.0, February 2009
Default Factory Settings
When you first receive your wireless access point, the default factory settings are set as shown
below. You can restore these defaults with the Reset button on the rear panel (see
“Rear Panel” on
page 1-6
).
Feature
Factory Default Settings
User Name (case sensitive)
admin
Password (case sensitive)
password
Operating Mode
Access Point
Access Point Name
netgearxxxxx8 where xxxxx are the last five digits of the
wireless access point's MAC address
Built-in DHCP client
DHCP client disabled, it uses the default IP address
IP Configuration
IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID)
NETGEAR
Broadcast Network Name (SSID)
Enabled
Super-G Mode
Disabled
WEP/WPA
Disabled
MAC Access Control
Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Time Zone
USA-Pacific
SNMP
Disabled
VLAN (802.1Q)
Disabled
WMM Support
Enabled
WMM Power Save
Enabled
