WG103 ProSafe 802.11g Wireless Access Point Reference Manual
Basic Installation and Configuration
2-13
v1.0, February 2009
4.
Connect the power adapter to the wireless access point, and plug the power adapter in to a
power outlet. The PWR and LAN LEDs should light up.
5.
Verify wireless connectivity.
Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless
settings (see
“Testing Basic Wireless Connectivity” on page 2-12
), verify connectivity by
using a browser such as Internet Explorer or Mozilla Firefox to browse the Internet, or check
for file and printer access on your network.
Note:
By default, the wireless access point is set with the DHCP client disabled.
If your network uses dynamic IP addresses, you must change this setting.
Tip:
The wireless access point supports Power Over Ethernet (PoE). If you have a
switch that provides PoE, you will not need to use the power adapter to power
the wireless access point. This can be especially convenient when the wireless
access point is installed in a high location far away from a power outlet.
Note:
If you are unable to connect, see
Chapter 6, “Troubleshooting
.”
