NETGEAR ProSafe FWAG114, Reference Manual

Page: 111 / 192

Troubleshooting 9-1
Chapter 9
Troubleshooting
This chapter gives information about troubleshooting your ProSafe Dual Band Wireless VPN
Firewall FWAG114. After each problem description, instructions are provided to help you
diagnose and solve the problem.
Basic Functioning
After you turn on power to the router, the following sequence of events should occur:
1.
When power is first applied, verify that the PWR LED is on.
2.
After approximately 10 seconds, verify that:
a.
The TEST LED is not lit.
b.
The LAN port LEDs are lit for any local ports that are connected.
c.
The Internet port LED is lit.
d.
The Wireless 802.11a is off and the LED is not lit until the country selection has been set.
If a port’s LED is lit, a link has been established to the connected device. If a LAN port is
connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the
LED will be amber.
If any of these conditions does not occur, refer to the appropriate following section.
Power LED Not On
If the Power and other LEDs are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
• Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.