NETGEAR Wireless-N 300 Router JWNR2000 User Manual
Configuring Basic Connectivity
1-11
v1.0, February 2010
1.
Select
Wireless Settings
under Setup in the main menu of the JWNR2000 router.
2.
For the wireless network name (SSID), use the default name, or choose a suitable descriptive
name. In the
Name (SSID)
field, you can enter a value of up to 32 alphanumeric characters.
The default SSID is NETGEAR.
3.
Select the region in which the wireless interface will operate.
4.
Set the channel. The default channel is
Auto
.
This field determines which operating frequency is used. It should not be necessary to change
the wireless channel unless you notice interference problems with another nearby wireless
router or access point. Select a channel that is not being used by any other wireless networks
within several hundred feet of your router. For more information about the wireless channel
frequencies, click the link to the online document
“Wireless Networking Basics” in
Appendix B
.
5.
Make sure that the mode is set to
Up to 145Mbps
.
Figure 1-9
Note:
The SSID is case-sensitive; NETGEAR is not the same as nETgear. Also, the
SSID of any wireless access adapters must match the SSID you specify in the
JWNR2000 router. If they do not match, you will not get a wireless connection
to the JWNR2000 router.
Summary of Contents for JWNR2000 - Wireless- N 300 Router
Page 8: ...v1 0 February 2010 viii ...
Page 16: ...NETGEAR Wireless N 300 Router JWNR2000 User Manual xiv v1 0 February 2010 ...
Page 132: ...NETGEAR Wireless N 300 Router JWNR2000 User Manual 7 12 Troubleshooting v1 0 February 2010 ...
Page 138: ...NETGEAR Wireless N 300 Router JWNR2000 User Manual B 2 Related Documents v1 0 February 2010 ...