NetEx/IP Parameter
Default
Description
segsize
32768
This is the maximum size of a single trans-
mission data block over the network.
smax
110
This is the maximum number of users active
at any one time. If this value is changed, the
file specified by “mbxname” above should be
deleted.
timer
2
This is the initial value for the watchdog ti-
mer.
The following parameters are only applicable to protocol type 4 connections:
defstartkbitspersec
0
This is the starting throughput rate at which
NetEx/IP will attempt to deliver data to the
network for each network connection. If zero
is specified, data will be delivered with no
internal throttling. This value is only used for
connections to hosts that do not have a ‘rate’
value specified in the PAM or NRB.
This value is specified in Kbits per second.
For example, a value of 50 means 50Kbs; a
value of 50000 means 50Mbs (i.e. 50,000
Kbs).
ratedelaydecp
250 (25.0%)
This is the percentage factor used to decrease
the sending rate of a network connection if the
round-trip delay increases. This recalculation
is performed after the expiration of each in-
terval specified by the ‘rtdelayincsecs’ pa-
rameter. The value specified represents a per-
centage multiplied by a factor of 10.
rateequivph
975 (97.5%)
This is the upper bound of the send and re-
ceive equivalence adjustment (see ‘rate-
equivps’). The value specified represents a
percentage multiplied by a factor of 10.
rateequivpl
500 (50.0%)
This is the lower bound of the send and re-
ceive equivalence adjustment (see ‘rate-
equivps’). The value specified represents a
percentage multiplied by a factor of 10.
MAN-REF-COSW 2.10-19
Appendix B
Page
25
