NetApp SteelStore 30 Series, Owner'S Manual

Page: 40 / 71

Operation
35
4.4 LEDs and Controls
4.4.1 Ops Panel LEDs and Switches
The Ops Panel LEDs ( Figure 4–2 ) fault and status conditions are defined in Table 4–1 while the
functions of the push-button switches are defined in Table 4–2 .
Refer to Chapter 5 , “Troubleshooting” on page 39 for details of any fault indication.
LED Status
Power Active • Constant green: system has full power and is running.
• Off: system is off or in standby mode.
Unit Fault Constant amber: there is a fault with the appliance.
Appliance ID Blue: only when activated via the ID LED switch or the appliance firmware.
Push-Button Switches Definition
On/Off • Powers the appliance on if currently off.
• Powers the appliance off if currently on (hold the switch down for at
least four seconds).
System Reset Resets the appliance hardware and firmware. The button is recessed and
must be activated with a ball-point pen or similar implement.
ID LED Toggles the state of the blue ID LEDs on the Ops Panel and the back of the
appliance. Also mutes the audible alarm if it is sounding.
Note
The Ops Panel is supplied as an integral part of the appliance core product and is not user replaceable.
Figure 4–2 Ops Panel LEDs and Switches
Table 4–1 Ops Panel LEDs
Table 4–2 Ops Panel Switches