NetApp SteelStore 30 Series, Owner'S Manual

Page: 23 / 71

NetApp SteelStore Cloud Integrated Storage xx30 Series Hardware Owner’s Manual
18
2.4.4 ATX Server LEDs
2.4.4.1 Server Status LEDs
The ATX Server I/O panel, shown in Figure 2–5 , contains diagnostic LEDs to help you identify failed
and failing components and to help you identify the server from among several servers. Section 4.4.6.1
on page 37 summarizes the LED states.
2.4.4.2 Network Port LEDs
The network port LEDs provide the information shown in 4.4.6.2 on page 38 .
2.4.4.3 ID LED
This is the appliance identification LED (there is a duplicate LED on the Ops Panel).
2.5 Operator’s (Ops) Panel
The appliance front panel incorporates an Operator’s (Ops) Panel, shown in Figure 2–7 .
Important The Ops Panel is an integral part of the appliance chassis assembly and is not field replaceable.
This assembly incorporates a USB socket, three LEDs and three buttons, with the following functions:
• LEDs:
– Green: The appliance is powered on.
– Amber: The appliance has detected a fault.
– Blue: Appliance identification LED.
• Buttons:
– On/off: Powers the system on or off (if held down for at least four seconds). However, note that
the system should be shut down using the procedure in
4.2 on page 34 .
– System reset: Reboots the hardware and firmware. Use the tip of a ballpoint pen to press the
recessed button.
– ID LED: Toggles the blue appliance identification LED; mutes the audible alarm.
• USB port. This port is for service personnel only.
Refer to section 4.4.1, “Ops Panel LEDs and Switches” on page 35 for a full description of the LED and
switch functions.