NetApp SteelStore 30 Series, Owner'S Manual

Page: 35 / 71

NetApp SteelStore Cloud Integrated Storage xx30 Series Hardware Owner’s Manual
30
5 Ensure the pins are securely located at both the front and rear, so that any load on the rail is transferred
to the rack posts.
6
Install the front and rear clamping screws, marked in Figure 3–3 . There are 4 screws in total – left and
right sides, front and rear. The screws should be left loose enough to allow the rail to move sideways in
its slots.
7
Slide the chassis fully home on the rails ( Figure 3–4 ).
8
Withdraw the chassis approximately 200 mm and fully tighten the front and rear rail clamping screws.
9
Fasten the front of the chassis using the two captive screws.
Figure 3–3 Securing Brackets to Rack