NetApp E2600, Installation Manual

Page: 96 / 142

88 E2600 Controller-Drive Tray Installation Guide
ATTENTION Potential damage to equipment (Network Telecommunications Equipment (NEBS) Ethernet
cable installations only)
– The intra-building port(s) (Ethernet maintenance ports) of this equipment is suitable for
connection to intra-building or unexposed wiring or cabling only. The intra-building port(s) of this equipment must
be metallically connected to interfaces that connect to the Outside Plant (OSP) or its wiring. These interfaces are
designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and
require isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient protection in
order to connect these interfaces metallically to OSP wiring. The cable shall be shielded Twisted Pair (STP) and must
be grounded at both ends to meet the intra-building lightning requirements from section 4.6.9.2 of GR-1089-CORE,
Issue #5.
Things to Know – Drive Trays with the E2660 Controller-Drive Tray
Each DE6600 drive tray can contain a maximum of sixty 8.89-cm (3.5-in.) drives housed with five drawers of 12
drives each.
Things to Know – E2660 Drive Tray Cabling Configurations – Duplex System
The figures in this topic show examples of cable configurations from the controller-drive tray to the drive trays. Use
these examples as guides to connect cables in your storage array.
Figure 85 Controller-Drive Tray Above the Drive Tray