NetApp E2600, Installation Manual

Page: 35 / 142

E2600 Controller-Drive Tray Installation Guide 27
Table 10 NetApp Supported SFPs
Refer to your Technical Support representative for the latest information about new switches that are tested and
certified to work with various hardware and software combinations.
Procedure – Installing and Configuring Switches
1. Install your switch according to the vendor’s documentation.
2. Refer to your Technical Support representative to obtain this information:
—
The latest hardware compatibility information
—
The models of the switches that are supported
—
The firmware requirements and the software requirements for the switches
3. Update the switch’s firmware by accessing it from the applicable switch vendor’s website.
This update might require that you cycle power to the switch.
4. Find your switch in the following table to see whether you need to make further configuration changes. Use
your switch’s configuration utility to make the changes.
Table 11 Supported Switch Vendors and Required Configuration Changes
Vendor Version/Data Rate
Avago 8G
10G
Finisar 1G
8G
10G
JDSU 8G
10G
Molex 8G
Opnext 10G
Switch Vendor Configuration Changes Required? Next Step
Brocade Yes
Change the In-Order Delivery (IOD)
option to ON.
Make the change, and go to
“
Installing the Host Bus Adapters for
the E2600 Controller-Drive Tray ” on
page 29 .
Cisco Yes
Change the In-Order Delivery (IOD)
option to ON.
LSI No “ Installing the Host Bus Adapters for
the E2600 Controller-Drive Tray ” on
page 29 .
McData No
QLogic No
PowerConnect No