NetApp E2600, Installation Manual

Page: 112 / 142

E2600 Controller-Drive Tray Installation Guide 104
Table 22 LEDs on the Controller Canister Main Faceplate
Location LED Color On Off
1 Ethernet Connector
1 Link Rate LED Green There is a 100BASE-T rate. There is a 10BASE-T rate.
2 Ethernet Connector
1 Link Active LED Green The link is up (LED blinks
when there is activity). The link is not active.
3 Ethernet Connector
2 Link Rate LED Green There is a 100BASE-T rate. There is a 10BASE-T rate.
4 Ethernet Connector
2 Link Active LED Green The link is up (the LED
blinks when there is
activity). The link is not active.
5 Host Link 1
Service Action
Required LED Amber At least one of the four
PHYs is working, but
another PHY cannot
establish the same link to
the device connected to the
Host IN port connector. No link error has occurred.
6 Host Link 1
Service Action
Allowed LED Green At least one of the four
PHYs in the Host IN port is
working and a link exists to
the device connected to the
IN port connector. A link error has occurred.
7 Host Link 2
Service Action
Required LED Amber At least one of the four
PHYs is working, but
another PHY cannot
establish the same link to
the device connected to the
Host IN port connector. No link error has occurred.
8 Host Link 2
Service Action
Allowed LED Green At least one of the four
PHYs in the Host IN port is
working and a link exists to
the device connected to the
IN port connector. A link error has occurred.
9 Battery Service
Action Required
LED Amber The battery in the controller
canister has failed. Normal status.
10 Battery Charging
LED Green The battery is fully
charged. The LED blinks
when the battery is
charging. The controller canister is
operating without a battery
or the existing battery has
failed.
11 Controller Service
Action Allowed
LED Blue The controller canister can
be removed safely from the
controller-drive tray. The controller canister
cannot be removed safely
from the controller-drive
tray.