NetApp E2600, Installation Manual

Page: 45 / 142

E2600 Controller-Drive Tray Installation Guide 37
—
If you are installing the mounting rails above an existing tray, position the mounting rails directly above
the controller-drive tray.
—
If you are installing the mounting rails below an existing tray, allow 17.8-cm (7-in.) vertical clearance for
a E2660 controller-drive tray.
5. To attach the mounting rails to the cabinet, do one of the following:
—
If you are using the long fixed size mounting rails, go to step 6 .
—
If you are using the shorter adjustable mounting rails, go to step 7 .
6. To attach the long mounting rails to the cabinet, perform these substeps:
a. Make sure that the adjustment screws on the mounting rail are loose so that the mounting rail can
extend or contract as needed.
Figure 31 Attaching the Long Mounting Rails to the Cabinet
1. Front of the Mounting Rail
2. Two M5 Screws for the Rear EIA Support Rail
3. Front of the Cabinet
4. Two M5 Screws for the Front EIA Support Rail
5. Adjustable Rail Tightening Screws
6. Rear Hold-Down Screw
7. Cabinet Mounting Holes on the Front EIA Support Rail
8. Cabinet Mounting Holes on the Rear EIA Support Rail
9. Mounting Rail Lip
b. Remove the rear hold-down screw. It protrudes from the inside of the rail and prevents you from
sliding the drive tray onto the rails.
c. Place the mounting rail inside the cabinet, and extend the mounting rail until the flanges on the
mounting rail touch the inside of the cabinet.
d. Insert one M5 screw through the front of the cabinet, and screw it into the top captured nut in the
mounting rail.
e. Insert two M5 screws through the rear of the cabinet, and screw them into the captured nuts in the
rear flange in the mounting rail.
f. Tighten the adjustment screws on the mounting rail.
g. Repeat substep a through substep f to install the second mounting rail.