NetApp E2600, Installation Manual, Page: 13 / 142

E2600 Controller-Drive Tray Installation Guide 5
E2600 Configuration Cables and Connectors
Table 4 Cables and Connectors
Mounting rails and screws
The mounting rails that are available with the drive tray
are designed for an industry-standard cabinet.
Fibre Channel switch (optional)
SAS switch (optional)
Gigabit Ethernet switch (optional)
„
Host with Fibre Channel host bus adapters (HBAs)
(optional)
„
Host with iSCSI HBAs (optional) or a network
interface card (optional)
„
Host with SAS HBAs (optional)
Item
Included with the
Controller-Drive
Tray or Drive Trays
AC power cords.
The controller-drive tray and the drive trays ship with
power cords for connecting to an external power source,
such as a wall plug. Your cabinet might have special power
cords that you use instead of the power cords that ship with
the controller-drive tray and the drive trays.
(Optional) Two DC power connector cables are provided
with each drive tray for connection to centralized DC
power plant equipment.
„
Four DC power connector cables are provided if
additional redundancy is required.
„
A qualified service person is required to make the
DC power connection per NEC and CEC
guidelines
. A two-pole 20-amp circuit breaker is
required between the DC power source and the drive
tray for over-current and short-circuit protection.
Before turning off any power switches on a
DC-powered drive tray, first you must disconnect the
two-pole 20-amp circuit breaker.
For the DC power
option only
Item
Included with the
Controller-Drive
Tray