![Net2Phone 8 Plus User Manual Download Page 29](http://html1.mh-extra.com/html/net2phone/8-plus/8-plus_user-manual_1669728029.webp)
Max 8 and 8 Plus User’s Guide – Chapter 2
21
E
NTERING A
N
ETMASK
A
DDRESS FROM A
T
ELEPHONE
K
EYPAD
To enter a netmask address:
1. Lift the handset and dial
***
3
(the netmask
parameter code).
The voice prompt responds,
“Please enter your netmask.”
2. Dial the numbers for the netmask address you
wish to enter on the telephone keypad. Use the
star key (
*
) to replace the periods in the address
and end with the pound key (
#
).
The voice prompt responds, “Your netmask is…”
and repeats the address you entered.
3. If the new address is correct, simply hang up the
telephone. If the new address is incorrect, hang
up the telephone and repeat from step 1, above.
4. Reset the Max 8 to activate the changes. To do
this, power-off the unit, wait 10 seconds, and turn
it on again.
The new net mask address is now in effect.
If you are using static IP addresses, you are now ready to
finish setting up the Max 8 using the Max Web Manager.
Proceed to Chapter 3,
Logging in to the Max Web
Manager.
R
E
-
ENABLING
DHCP
FROM A TELEPHONE KEYPAD
If you need to re-enable DHCP in the Max 8, proceed as
follows:
1. Lift the handset and dial
***
4
(the enable DHCP
parameter code).
The voice prompt announces, “DHCP is enabled
now. Please press pound.”
2. Press the pound key (
#
).
3. Reset the Max 8 as directed in Step 4 in the
Entering an IP address from a Telephone
Keypad
section on page 20 in this Guide.
DHCP is now enabled.
Summary of Contents for 8 Plus
