10
Set Audible and Visual Response
Programming Step
Keystroke Combination
1. Enter Program Mode
*
(Master Code) #
2. Control Sounds
OR
2. Control LED
OR
2. Control Keypad Backlit
OFF =
7 0 #
OFF =
7 4 #
OFF =
7 6 #
ON =
7 1 #
ON =
7 5 #
ON =
7 7 #
(factory defaults are ON)
3. Exit
*
Master Cards Usage
Using Master Cards to add and delete card users
Add a User
1.
(Read Master Add Card)
2.
(Read User Card)
Repeat Step 2 for additional user cards
3.
(Read Master Add Card)
Delete a User
1.
(Read Master Delete Card)
2.
(Read User Card)
Repeat Step 2 for additional user cards
3.
(Read Master Delete Card)
Users Operation & Reset to Factory Default
- Open the door: Read valid user card or inputting valid user PIN
- Remove Alarm: Read valid user card or inputting valid user PIN, or input Master Code #
-
To reset to factory default & Add Master Cards
: Power off, press the Exit Button, hold it and power on, there will
be two beeps, and the LED light turns into yellow, release the exit button, then read any two 125KHz EM cards, the
LED will turn into red, means reset to factory default successfully. Of the two cards reading, the 1
st
one is Master Add
Card, the 2
nd
one is the Master Delete Card.
Remarks:
①
If no Master Cards added, must press the Exit Button for at least 10 seconds before release.
②
Reset to factory default, the user’s information is still retained.
NOTE:
(The Ness XK Units have some factory set adjustments after it has been ‘defaulted’. It is set in the factory as
26 Bit Wiegand and 10 Digit Virtual Number for when a PIN is entered. If a factory reset is performed onsite then
these settings need to be manually reset back on again to have the units set as it was in the factory.)
