Neopost AS-940, Operating Manual

Page: 17 / 50

SECTION 2
INSTALLATION & SETUP
Loading Media
When placing media into the printer, it is important to follow these steps.
1. Start by placing a single piece of media into the feed
section, so that it is touching or starting to feed under
the sheet separators.
2. Before adding media; fan the stack of material so the
bottom pieces are closest to the separation point, as
shown in
. Then carefully place the stack
between the side guides, so the leading edge of the
stack is against the sheet separators, as shown in
.
Figure 23
Figure 24
3. Additional pieces can be placed onto the stack, as
described in the above step.
4. If the printer runs out of material, be sure to reload
the printer beginning with the first step.
Figure 22
Figure 23
© 2009 Neopost USA Inc. All rights reserved. 17