Neopost AS-940, Operating Manual

Page: 15 / 50

SECTION 2
INSTALLATION & SETUP
Setting up the Feed System
The printer is equipped with four sheet separators, two media side guides, a rear media guide, and a media
thickness adjustment dial.
Sheet Separation Adjustment
The sheet separators are adjusted individually as follows:
1. Move the side guides so that the separators and
separator locking lever are accessible.
2. Release the Separator Locking Lever, by pulling it
forward and down, as shown in
. Figure 15
3. Lift each individual separator up, until it locks in
the upper position, as shown in
. Figure 16
4. Place a single piece of media under the separators,
as shown in
.
It is best to place the media so it is in the center
position on the table.
Figure 17
5. Unlock the separators that have media beneath
them and allow them to fall (by their own weight)
onto the media, as shown in
.
Repeat for each separator that has media under it.
IMPORTANT
Be sure that unused separators are locked in their
raised position. If not, they will rub on the feed
rollers, causing transport problems and damage to
the rollers and separators.
Figure 18
6. Raise the Separator Locking Lever, by lifting it up
and back, as shown in
. This will lock
the separator positions.
Figure 19
Figure 14
Figure 16
Figure 17
Figure 18
Figure 1 5
© 2009 Neopost USA Inc. All rights reserved. 15