SECTION 2
INSTALLATION & SETUP
Media Side Guide Adjustments
Figure 19
1.
Loosen the Media Side Guide Securing Knobs, as
shown in
.
Figure 20
2.
Move the side guides apart, so the media will fit
between them and be centered in the feed area.
3.
If not already present; place one piece of media
between the side guides, so the media is centered in
the feed area.
4.
Adjust the Media Side Guides so that they are about
a dimes width (~1/32-inch) from the sides of the
media, as shown in
.
Figure 21
5.
Tighten the Media Side Guide Securing Knobs, to
secure the side guide positions.
Figure 20
Rear Media Guide Adjustments
1.
Place two pieces of media into the hopper, making sure the leading edges of the media is resting
against the separators.
2.
Adjust the Rear Media Guide position by sliding it up or down on the Rear Media Support.
Position it so that the trailing edge of the media is raised approximately ½ to 1 inch above the Rear
Media Support, as shown in
.
Figure 22
Figure 21
0.5” – 1”
GAP
© 2009 Neopost USA Inc. All rights reserved.
16
Summary of Contents for AS-940
Page 1: ...AS 940 Addressing Solution Operating Guide...
Page 12: ...SECTION 1 GETTING ACQUAINTED Notes 2009 Neopost USA Inc All rights reserved 12...
Page 36: ...SECTION 3 OPERATING THE PRINTER Notes 2009 Neopost USA Inc All rights reserved 36...
Page 42: ...Notes 2009 Neopost USA Inc All rights reserved 42...
