Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
44
9 CAN bus (SAE J1939) and CAN-scanner
9.1 Tracker connection to vehicle CAN-bus
Tracker connection to Can -bus allows receiving data being transmitted via bus in FMS
standard. For this purpose, you should connect corresponding line of vehicle CAN bus to the
contacts CAN_H, CAL_L (9,21 contacts of MF-24F plug).
Use connection layout given in Figure 20 while connecting to diagnostic outlet.
If in the connection point to the bus between lines CAN_H and CAL_L there is resistance of
~120 Ohm (when ignition is disabled) then you should connect 120 Ohm resistance near the
tracker between 9 and 21 contacts.
There is no need for additional resistor if resistance is ~60Ohm. As a rule, while connecting
to diagnostic connector there is no need to use a resistor.
When connecting to Can bus use connection layout given on Figure 21.
