Neomatica, LLC. Terminal ADM700 3G GLONASS/GPS. Ed. 7.2, dd. 24.11.2018
15
⎯
commands transmission syntax is the same for SMS, GPRS and USB;
⎯
all commands syntax: «CMD X1,…,X3», where CMD is a command, X1..X3 are commands
parameters.
⎯
commands are separated by a SPACE. Parameters are separated by commas, except for
the DN0 command which parameters are separated by a colon.
After receiving a command, the tracker executes it and sends a feedback.
If the command parameters extend beyond the acceptable range, the tracker changes them
to the nearest acceptable values. If it is not possible to change parameters or parameters are not
enough, the tracker will answer with an error message. The command without parameters will
restore to the current settings.
To set the terminal via USB it is necessary to install the ADMConfigurator program available
If a password has been set, it should be entered immediately
after connection in the respective ADMConfigurator program window. If the tracker works with a
default password (“0”), it is not necessary to enter the password.
No authorization is required for configuration via GPRS.
6.1 Phone number authorization
To handle the tracker via SMS-
commands it is necessary to send the SMS command «
ADD
ME 0
» to the SIM-card number installed in the tracker, where 0 is the default password. If the
password has been changed, the new one should be indicated.
The phone number, which
such a command is sent from, will be authorized in the
tracker
. In response, an SMS
containing the authorized phone numbers list will be sent. If a wrong password is
entered, the SMS will not be sent, and the command will be disregarded. The
authorized phone numbers list might be requested with the
«PHONES»
command.
The authorized phone numbers list is stored in non-volatile memory. The maximum quantity
of phone numbers saved is 4. Clearing the authorized phone numbers list is made by restoring to
factory settings.
6.2 Server connection settings
Set APN parameters for the selected mobile operators by the «
SETGPRS0
» command for
SIM card 0 and «
SETGPRS1
» for SIM card 1. Then set the IP-address and the server port (host)
by the «
SETHOST0
» command or «
DN0
».
These parameters change might be performed in graphical interface of ADMConfigurator
program.