13
3.4.4.2. Recording Off - Video recording Off
3.5. In case there is no SD card.
In case there is no SD card in SD slot, “Please insert SD card” text and Beep will be shown and heard.
4. Parking mode
During parking (or stop) condition, if the unit recognizes any shocks with car or any motion in front of car, it starts
recording automatically
4.1. It enters into the parking mode in the following two cases.
4.1.1. Car engine off (at the condition that all time power is connected)
-
When Car Engine is Off, it enters into the parking mode immediately.
-
When Car engine is On, it gets out of the parking mode.
4.1.2. In case there is no motion for the setting time
-
If Car does not move for the setting time, it enters into the parking mode.
-
If Car moves, it gets out of the parking mode.
-
In case of Parking mode entrance time = 0ff , it does not enter into the parking mode unless there is
a motion.
4.2. Recording time at Parking mode
At Parking mode, when there is any event like any shock or any motion in front of car, the video before 10
seconds and after 50 seconds from the event will be stored at “Event” folder.
4.3. Video resolution and frames at Parking mode
The Video resolution at parking mode will be recorded as you set at Setting mode -> Video settings ->
Resolution.
Resolution to be able to set : 1920*1080 (real Full HD) / 1280*720(HD)
Recording frames: 15fps
4.4. Power saving at Parking mode
When the voltage of car battery becomes lower than 11.3V, X-COP 9100 will be power off even at parking
Summary of Contents for X-COP 9100
Page 31: ...31...
Page 34: ...34 The end...
