9
1.4. Select Button
1.4.1. Press “Select” button shortly at power On condition and it enters into Radar quick menu.
1.4.2. Press “Select” button shortly at the Menu and it is operated as ‘Select’ function.
1.4.3. Press and hold “Select” button for two seconds at power On condition and Manual recording will be
started. It records before 10 seconds ~ after 50 seconds.
1.4.4. Press and hold “Select” button for two seconds at power On (= power cable is not connected) and
the current screen will be captured. This captured screen will be stored at the “Event” folder of SD
card and the image resolution is 1920*1080 pixels.
1.5. RESET Button
X-COP 9100 uses a battery so that there may be a case of system down unexpectedly.
In this case, you can Re-booting by pressing the RESET button.
2. Power On and Off.
2.1. X-COP 9100 will power On when user starts car engine or presses the power button for two seconds and
will show the following start-up image and then become a normal screen as follows.
(LOGO display) (Normal screen)
2.2. X-COP 9100 will power Off when user turns off the car engine or presses the power button for two seconds.
3. All times display (Normal Screen)
Summary of Contents for X-COP 9100
Page 31: ...31...
Page 34: ...34 The end...
