Hangzhou NeoDen Technology Co.,Ltd.
16
②
The way about how to generate the circle panel when the component number is double
number: the project and rectangle of the “component type “are the same, we know it has 24
components by observation, the default angle is 0 here, input this value on your own. Because
if the total component is double number, we only need to find two symmetry to align. Click to
generate the 24 components coordinate in the circle panel.
起
元 器
Figure (2.1.3.2-6)
③
The way about how to mass generate the circle panel when the component number is
single number: item in the type of components is the same as mentioned above, the circle
panel is shown as figure(2.1.3.2-6), after observing the panel, we know it has 9
components , because the final number of components is single, it is better to find 3
components that are isosceles triangle, and then align the coordinates of those three points
in turn. Click to generate 9 components’ coordinate in circle panel.
起 始
点
元 器 件
2.1.4.2 Secondary editing of components
Function: add or alter for the information of components based on exist programming
Procedure: firstly, enter into the program edit page, see figure (2.1.4.2):
Put the PCB board into rail which is corresponding with programming, click the “feed” in the
access setting area, confirm the PCB at the designated place, then click “transform into
machine’s current coordinate” and confirm it, at this time, the machine will automatically scan
the fiducial and transform all existing components’ information into current coordinate
Initial
point
Compo
nent
point 2
Initial
point
Component point 2
point 3
Summary of Contents for 7
Page 4: ......
