20
4.
To remove the brush, press the shaft lock firmly to prevent the
spindle from turning, then use the lock nut wrench to loosen
the brush.
Mounting a Wire Wheel Brush
For International versions of the Nemo Submersible Angle Grinder,
use a wheel guard and brush for an M14 (14mm) spindle. For U.S.
versions, use a wheel guard and brush for a 5/8 in 11 UNC spindle.
1.
Ensure the speed selector switch is in the Off position (0).
Caution:
To minimize the risk of accidental activation,
ensure the speed selector switch is in the Off (
0
)
position before performing any maintenance on the
angle grinder, as well as during transport and storage.
2.
Press the shaft lock firmly to prevent the spindle from turning,
then thread the brush (1) on to the spindle, on top of the wheel
guard, and use the lock nut wrench to secure it in place.
3.
To remove the brush, press the shaft lock firmly to prevent the
spindle from turning, then use the lock nut wrench to loosen
the brush.
Summary of Contents for AG-22-5Li-50
Page 1: ......
