11
To put the dust container and the filter unit back together, you must insert the filter unit
so that the upper arrow points towards the open lock symbol.
12
Turn the dust container lid until the upper arrow points towards the closed lock symbol and
locks itself in place.
13
Insert the dust container into the vacuum cleaner. You should hear a click
when it is locked in place.
CLEANING THE HEPA FILTER
The HEPA filter is located in the filter unit in the dust container and should be cleaned regularly to ensure that the suction
power of your vacuum cleaner is not reduced and that the motor is not overloaded.
1
Hold down the release button on the handle of the dust container and remove
the dust container from the vacuum cleaner.
2
Open the dust container by releasing the fastener clip (A) and lifting up the dust container lid.
3
Remove the HEPA filter (B) by pulling it out.
4
Below the HEPA filter there is another foam filter. Remove it for cleaning.
5
Tap the HEPA filter out over an open dustbin. Clean the filter using a brush if necessary.
Never clean the HEPA filter with water.
6
Tap the foam filter out over an open dustbin. If necessary, you can rinse the foam filter with
clear cold water. Allow it to dry completely before inserting it again.
7
Place the dry foam filter back into the filter unit.
8
Insert the HEPA filter back into the filter unit.
9
Close the dust container lid. You should hear a click when it is locked into place.
10
Insert the dust container back into the vacuum cleaner. You should hear a click
when it is locked into place.
A
B
9
