16
5-2-3 Mounting Illuminator on NEO Frame
(1)
Loosen two screws mounted on the hinge of Illuminator, shown in Fig. 5-2-7,
approximately 3mm. Do not remove them from the hinge.
(2)
Put the hinge of Illuminator onto the hinge of the Loupe and firmly tighten the loosened two
screws.
(3)
For wiring the Cord of Illuminator, if a frame strap is previously attached, remove it
temporarily.
(4)
Pull the Forehead Cushion out of the center as shown in Fig. 5-2-8 to remove it. Set the
Cord inside of the Forehead cushion as shown in Fig. 5-2-9, then put back the cushion
again. Loosely set the Cord, so that the Illuminator can move up and down (vertically) and
right and left (horizontally) freely and smoothly without any tension.
Hinge on
Loupe
Illuminator
Two Screws on Hinge
of Illuminator
Loupe
Fig. 5-2-7
Set Cord inside of
Forehead Cushion
Pull the Forehead
Cushion out of the center.
Fig. 5-2-8
Fig. 5-2-9
Forehead Cushion
Cord
